NAME

dr_cmd_auto_config - run Solaris reconfig sequence on target domain

SYNOPSIS

dr_cmd_auto_config

DESCRIPTION

Caution:

Do not use this command; use reconfig(1M) instead. Only authorized service providers should use dr_cmd_auto_config, which runs in the DR shell, and only when they cannot use reconfig(1M). Performing this operation may cause device files to be remapped and known devices to be renamed.

The system administrator would normally run dr_cmd_auto_config after a new system board has been attached to a running domain to make the devices on the boards available immediately. The automatic configuration on Solaris consists of the following SunOS commands, in the order shown:

drvconfig(1M), devlinks(1M), disks(1M), and tapes(1M).

EXIT STATUS

If dr_cmd_auto_config succeeds it returns a 0 result code in the dr_return global variable. If it fails, it returns a 1.

Note:

Tcl parsing errors prevent DR commands from running which, in turn, leaves dr_return uninitialized. In such cases, the dr_return error code is meaningless. See dr (1M)for more information concerning return codes.

DIAGNOSTICS

See DIAGNOSTICS on the reconfig(1M) man page.

SEE ALSO

reconfig(1M) in this Reference Manual

dr_daemon (1M) in the Solaris Reference Manual for SMCC-Specific Software

drvconfig(1M), devlinks(1M), disks(1M), ports(1M), tapes(1M) in man Pages(1M): System Administration Commands