NAME

cg14config - configure the cgfourteen device

SYNOPSIS

/usr/platform/platform-name/sbin/cg14config [ -d device ] [ -r resolution ] [ -g gammavalue ] [ -G gammafile ] [ -u degammavalue ] [ -U degammafile ]

DESCRIPTION

cg14config sets up state on the selected cgfourteen device. platform-name can be found using the -i option of uname(1).

cg14config is supported only on Desktop SPARCsystems with SX graphics option.

The interface, output, and command location are uncommitted and subject to change in future releases.

OPTIONS

-d device

Use device as the cgfourteen device to configure. Default is /dev/fb.

-r resolution

Use resolution as the desired screen resolution. Resolution is specified in terms of screen width and height (in pixels), and vertical refresh (in hz). Available resolutions are:

1024x768@60

1024x768@66

1024x768@70

1152x900@66

1152x900@76

1280x1024@66

1280x1024@76

1600x1280@66

1920x1080@72

The default is the value read from the monitor sense codes. Note that some or all of the resolutions above may not be supported by any given monitor. If a programmed resolution is outside of the range of allowable values for a monitor, unpredictable results can occur, including damage to the monitor. Thus, care should be taken when programming the resolution. See Openboot Command Reference for a description of how to reset the console device to the default value if it becomes unusable from programming an unsupported resolution.

The -r option is not available when the window system is running.

-g gammavalue

Each entry of the gamma lookup table will be loaded with

entry^(1/gammavalue). The gamma lookup table has 256 entries. Default gammavalue is 2.2 .

-G filename

Initialize the gamma lookup table with the contents of filename. The format of filename is 256 triplets (red green blue) of non-negative integers separated by NEWLINE characters. The integers must be in the range 0 to 1023, inclusive.

-u degammavalue

Each entry of the degamma lookup table will be loaded with

entry^(degammavalue ). The degamma lookup table has 256 entries. Default degammavalue is 2.2 .

-U filename

Initialize the degamma lookup table with the contents of filename. The format of filename is 256 entries of non-negative integers separated by NEWLINE characters. The integers must be in the range 0 to 255, inclusive.

EXIT STATUS

cg14config returns 0 on success and a positive integer on failure.

1

Selected device is not a cgfourteen device.

2

Requested action failed.

3

Unsupported resolution.

4

Gamma or degamma value out of range.

FILES

/platform/platform-name/kernel/drv/cgfourteen

cgfourteen device driver

ATTRIBUTES

See attributes(5) for descriptions of the following attributes:

ATTRIBUTE TYPE	ATTRIBUTE VALUE
Availability	SUNWkvm

SEE ALSO

uname(1), init(1M), mmap(2), attributes(5)

Platform Notes: SPARCstation 10SX System Configuration Guide
Openboot Command Reference