NAME

scsi_status - SCSI status structure

SYNOPSIS

#include <sys/scsi/scsi.h>

INTERFACE LEVEL

Solaris DDI specific (Solaris DDI)

DESCRIPTION

The SCSI-2 standard defines a status byte which is normally sent by the target to the initiator during the status phase at the completion of each command.

STRUCTURE MEMBERS

u_char

sts_chk

: 1,

/* check condition * /

          sts_cm      : 1,  /* condition met * /
          sts_busy    : 1,  /* device busy or reserved * /
          sts_is      : 1,  /* intermediate status sent * /
          sts_scsi2   : 1,  /* SCSI-2 modifier bit * /

sts_chk indicates that a contingent allegiance condition has occurred.

sts_cm is returned whenever the requested operation is satisfied

sts_busy indicates that the target is busy. This status is returned whenever a target is unable to accept a command from an otherwise acceptable initiator (i.e. no reservation conflicts). The recommended initiator recovery action is to issue the command again at a later time.

sts_is is returned for every successfully completed command in a series of linked commands (except the last command), unless the command is terminated with a check condition status, reservation conflict, or command terminated status. Note that host bus adapter drivers may not support linked commands (see scsi_ifsetcap(9F)). If sts_is and sts_busy are both set then a reservation conflict has occurred.

sts_scsi2 is the SCSI-2 modifier bit. If sts_scsi2 and sts_chk are both set then this indicates a command terminated status. If sts_scsi2 and sts_busy are both set then this indicates that the command queue in the target is full.

For accessing the status as a byte, the following values are appropriate:

STATUS_GOOD

This status indicates that the target has successfully com-

pleted the command.

STATUS_CHECK

This status indicates that a contingent allegiance condition

has occurred.

STATUS_MET

This status is returned what the requested operations are

satisfied.

STATUS_BUSY

This status indicates that the target is busy.

STATUS_INTERMEDIATE

This status is returned for every successfully completed command in a series of linked commands.

STATUS_SCSI2

This is the SCSI-2 modifier bit.

STATUS_INTERMEDIATE_MET
                      This status is a combination of STATUS_MET and
                      STATUS_INTERMEDIATE .

STATUS_RESERVATION_CONFLICT

This status is a combination of STATUS_INTERMEDIATE and STATUS_BUSY ,and is returned whenver an initiator

attempts to access a logical unit or an extent within a logical

unit is reserved.

STATUS_TERMINATED

This status is a combination of STATUS_SCSI2 and

STATUS_CHECK ,and is returned whenever the target termiantes the current I/O process after receiving a terminate I/O process message.

STATUS_QFULL

This status is a combination of STATUS_SCSI2 and

STATUS_BUSY ,and is returned when the command queue in the target is full.

SEE ALSO

scsi_ifsetcap(9F) scsi_init_pkt(9F), scsi_extended_sense(9S), scsi_pkt(9S)

Writing Device Drivers